3d-robotics 3DR DIY Quad Uživatelský manuál stáhnout pdf (Strana 20)

20

5 Leg assembly

Follow these instructions to assemble

one leg.

1 Assemble leg

Align the leg plates, and place a

stando between each of the bottom

three pairs of holes in the plates.

Secure each stando to the plates

with a 5 mm bolt on each end. Insert

the support plate into the horizontal

slots at the top of the leg.

2 Attach leg to arm

Align the two holes in the top of the

leg with the two holes in the center of

the arm. Orient the leg with the point

facing towards the center of the

copter. Insert two 25 mm bolts

through the arm and the leg, and

secure with metal nuts.

Repeat these steps for each leg of

your copter.

leg support plate

18 mm spacers

5 mm bolts

5 mm bolts

18 mm female-to-female

threaded standos (3)

5 mm bolts (6)leg plates (2) leg support plate

metal nuts (2)

25 mm bolts (2)

metal nuts

25 mm bolts

1 2 ... 15 16 17 18 19 20 21 22 23

Komentáře k této Příručce

Žádné komentáře