3d-robotics 3DR DIY Quad Uživatelský manuál stáhnout pdf (Strana 7)

2 Power system

wiring

Follow these instructions to connect

the power system.

1 Solder Deans to ESCs

Solder a Deans connector to the red

and black wires on each electronic

speed controller (ESC). Check the

Deans connectors for the + and –

markings, and solder the + side to

the red wire and the – side to the

black wire. Don’t forget to add heat

shrink tubing to the wires before

soldering, and shrink the tubing over

the ﬁnished connections.

2 Number ESCs

Use tape (or other method) to label

each ESC with a number one through

four.

Deans to ESC:

negative = black

positive = red

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Žádné komentáře

3d-robotics 3DR DIY Quad Uživatelský manuál Strana 7